VS00N SERIES H-Pile Points
Versa Steel H-Pile pointes are made of high strength, low alloy cast steel. Cast steel is a superior material choice because it’s isotropic – its properties are uniform in all direction. Cast steel points absorb impact and transfer it uniformly to the end of the pile
Tips are pre-beveled, eliminating pile end preparation. The weld prep is already built into the point, our castings have a 45 degree weld chamfer so there is no need to chamfer piles.
Weld procedure
1. To insure proper seating of the tip, remove all flash from end of pile and insert tip.
2. Using a 70xx series rod, make a single pass weld (see table) across each flange on the outside only.
3. Do not weld web or inside of flanges.
4. For heavier sections, you may want to use multiple welding passes.
No comments:
Post a Comment